Basement Waterproofing System

What is a Basement Waterproofing System?

basement waterproofing system is any that is used to identify service or repair either internally or externally, and solve leaky and wet basement problems. Identifying the source of a wet or flooded basement is the first step in any system, as dealing with the water source will make the difference in long term success. Waterproofing a basement can be done either internally or externally, and choosing which system to use will be as important as knowing the source of the problem. Solving the problem with leaky basements, means the job was done efficiently and will not happen again, any system does this, is a waterproofing system.

To fully understand the whole of any waterproofing system in basement repair, the mason doing the job must know where the water is coming from. Identifying the water source is the first and hardest step in basement waterproofing as it is sometimes hard to be absolutely certain of all the sources (as there could be more than one). Water coming from underground is the worst kind, but rain water, and leaky pipes can be other causes. In the case of things like leaky pipes or septic tanks, fixing the leak is the best way to solve the problem. In the case of rain water and surface water, backfilling the foundation and making a downgrade back away from the house is an excellent solution.

There are basically two kinds of basement waterproofing systems that can be applied within reason and still involve the earlier mentioned elements. External systems of basement waterproofing can be as easy as backfilling the foundation or as hard as digging up the foundation and putting layers of thick plastic tarping or vinyl underground gutters around the areas of hydrostatic pressure and whole foundation, complete with external sump pump. Internal solutions can be as easy as fixing a leaky pipe, or as complicated as building a sump pump and permanent ground gutters to relieve hydrostatic pressure, and special thick plastic tarping over the floor to stop dampness.

Basement Waterproofing System

In the end, any waterproofing system that solves the wet basement problem once and for all is the one to choose. But unless “all” the water sources were identified in the original inspection, seepage, damp walls, mildew, rust cracks, slumps, and sinkholes can all return to terrify the innocent and helpless homeowner on the worst of cold and stormy nights. If an internal sump pump and hydrostatic pressure relief system is being used, and old leaky lead pipes are still breaking all throughout the house, then obviously the only problem solved was surface or ground water. Backfilling the foundation can do the job of correcting the flow of a bad downspout or broken gutters, but if a septic tank or sewer line is suffering from old age and a smelly sink hole appears under the basement floor, then other actions must be taken. Making sure for ever and always that the basement is going to stay dry; is waterproofing.

Identifying the problem is the first thing any basement waterproofing system will do. Systems can be internally controlling an ongoing problem, externally redirecting or controlling it, as well as simply doing something about the source itself. Finally, any system that plans on waterproofing the basement, will need to be certain, that it has solved all the problems for good, otherwise, it will need to be done again. A good basement waterproofing system is one that does the job of ten workers, never complains, never gets sick, never grows old, and never dies. It’s a system that keeps the basement dry and waterproofed for all time.

1 thought on “Basement Waterproofing System”

Leave a Comment

Translate »